(Rock) [LP] [24/96] Dire Straits - 2 Original UK LP - 1978-1979, FLAC (tracks+.cue)

SHUNYATA RESEARCH HYDRA V-RAY VERSION II (Power distribution, conditioner and filter)
RCM: Clearaudio Smart Matrix (ClearAudio Pure Groove + L’Art du Son Cleaning Fluid + Osage brush)
Ultrasonic Cleaning (40 kHz) for 30?-60' at 35°C max. with personal blend of wetting agents and surfactants.
TURNTABLE: Dr. Feickert Blackbird + INERTIA platter
TONEARM: Reed 3Q 10,5" (Finewire C37 + Cryo WBT Nextgen, Armwand Pernambuco, Headshell with VTA and Azimuth laser adjustment)
CARTRIDGE: Dynavector DV DRT XV-1t
PHONO STAGE: Allnic H-3000 (+22 dB GAIN, charge impedance 118 Ohm)
ADC SYSTEM: Lavry Black AD11 external USB 2.0 ADC

CABLES:
FONO ACUSTICA ALLEGRO Interconnect Cable TS/RCA made expressly for me (for connecting phono preamp and ADC system)
SYNERGISTIC Research USB Active SE Cable with Enigma Tuning Circuits (for connecting ADC system and PC)
Furutech G-314AG-18 High performance Power Cable (4 power cables total)
Synergistic Research SR Core RCA (for connecting signal from the PC to the amplifier)

AND ALSO...
FURUTECH Destat II, Static charge remover
Lyra SPT (stylus performance treatment)
Platterspeed for iPod Touch (Dr. Feickert) speed verifier

SOFTWARE:
Adobe Audition CS6 (record 24/96)
Izotope RX3 Advanced (big clicks repair)
FLAC FRONTEND v.2.0 using FLAC 1.3.0 (WAV --> FLAC)

PENAUDIO REBEL3 Monitor Loudspeakers
HEGEL 100 Amplifier

RIPPING NOTE:
No Equalization, Minor Click repair (whenever possible an manual mode with Izotope RX), No Noise Reduction and No Normalization.
No silence been removed.
THE DYNAMIC RANGE OF THIS CAPTURE WAS NOT ALTERED IN ANY WAY DURING EDITING.
The two channels have been captured at the same volume level with my ADC system. The imbalance between channels, so you can appreciate, it's own vinyl or behavior of my phono preamp to valves. No two valves are identical. In addition, the azimuth of my tonearm-cartridge is perfectly checked by the device laser, being the difference between channels of ±0,2 db

SHUNYATA RESEARCH HYDRA V-RAY VERSION II (Power distribution, conditioner and filter)
RCM: Clearaudio Smart Matrix (ClearAudio Pure Groove + L’Art du Son Cleaning Fluid + Osage brush)
Ultrasonic Cleaning (40 kHz) for 30?-60' at 35°C max. with personal blend of wetting agents and surfactants.
TURNTABLE: Dr. Feickert Blackbird + INERTIA platter
TONEARM: Reed 3Q 10,5" (Finewire C37 + Cryo WBT Nextgen, Armwand Pernambuco, Headshell with VTA and Azimuth laser adjustment)
CARTRIDGE: Dynavector DV DRT XV-1t
PHONO STAGE: Allnic H-3000 (+22 dB GAIN, charge impedance 118 Ohm)
ADC SYSTEM: Lavry Black AD11 external USB 2.0 ADC

CABLES:
FONO ACUSTICA ALLEGRO Interconnect Cable TS/RCA made expressly for me (for connecting phono preamp and ADC system)
SYNERGISTIC Research USB Active SE Cable with Enigma Tuning Circuits (for connecting ADC system and PC)
Furutech G-314AG-18 High performance Power Cable (4 power cables total)
Synergistic Research SR Core RCA (for connecting signal from the PC to the amplifier)

AND ALSO...
FURUTECH Destat II, Static charge remover
Lyra SPT (stylus performance treatment)
Platterspeed for iPod Touch (Dr. Feickert) speed verifier

SOFTWARE:
Adobe Audition CS6 (record 24/96)
Izotope RX3 Advanced (big clicks repair)
FLAC FRONTEND v.2.0 using FLAC 1.3.0 (WAV --> FLAC)

PENAUDIO REBEL3 Monitor Loudspeakers
HEGEL 100 Amplifier

RIPPING NOTE:
No Equalization, Minor Click repair (whenever possible an manual mode with Izotope RX), No Noise Reduction and No Normalization.
No silence been removed.
THE DYNAMIC RANGE OF THIS CAPTURE WAS NOT ALTERED IN ANY WAY DURING EDITING.
The two channels have been captured at the same volume level with my ADC system. The imbalance between channels, so you can appreciate, it's own vinyl or behavior of my phono preamp to valves. No two valves are identical. In addition, the azimuth of my tonearm-cartridge is perfectly checked by the device laser, being the difference between channels of ±0,2 db